Epson Stylus Pro 9900 - Page 323

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 323
Confidential
5. Remove the four screws that secure the Shield Plate, and remove the three clamps
and the Shield Plate.
B) Black, Phillips, Bind S-tite M3x6: four pieces
6. Disconnect all the connectors on the Main Board.
7. Remove the three screws that secure the Main Board Assy, and remove the Main
Board Assy.
C) Black, Phillips, Bind S-tite M3x6: three pieces
Figure 4-189. Removing the Shield Plate
Figure 4-190. Connector location
Figure 4-191. Removing the Main Board Assy
Clamps
Clamp
Shield Plate
B
CN22 CN28
CN7*
CN8*
CN29
CN10* CN15*
CN11*
CN14*
CN18CN19*CN17CN23CN24*CN1
CN2*
CN3
CN4*
CN26*
*: Unused connectors
C
C
C
Main Board Assy