Epson Stylus Pro 9900 - Page 331

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 331
Confidential
4.4.8.6 Front Cover
This part is not an ASP.
1. Remove the Color Measurement Device. (p325)
2. Remove the Mounter. (p327)
3. Remove the six screws that secure the Front Cover.
A) Silver, Phillips, Round Washer Head S-tite M3x6: three pieces
B) Silver, Phillips, Pan P-tite with S.W & P.W. M3x10: two pieces
C) Silver, Phillips, Pan S-tite with S.W & P.W. M3x6: one piece
4. Hold up the Front Cover to remove it.
Figure 4-200. Removing the Front Cover (1)
Figure 4-201. Removing the Front Cover (2)
C H E C K
P O I N T
In the next step, make sure to confirm which screw is attached to
which location because various screws are used here.
A
Front Cover
B
C
Front Cover