Epson Stylus Pro 9900 - Page 356

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Overview 356
Confidential
Adjustments
Head Related
Adjustments
Air Leak Check for Ink Supply Sys.
Checks air leak status in the ink path when replacing ink tube, ink cartridge holder,
damper or when adjusting ink cartridge holder and damper joint section.
– √√p.401
Initial Ink Charge Flag ON/OFF
A flag for initial ink charge can be set or cleared as necessary after replacing the Main
Board.
√ ––p.403
PF Related
Adjustment
PF Timing Belt Tension Adjustment Adjusts the tension of the PF Timing Belt to a specified level.
– √√p.404
Skew Check Feeds paper to check skew level of the paper.
– √ – p.406
Band Feed Corrects a paper feeding amount.
– √ – p.407
T&B&S Adjustment Adjusts the top, bottom and side margins.
– √ – p.409
Paper Thickness Sensor Position
Adjustment
Adjusts the positions of Paper Thickness Sensor so as to detect the thickness of paper
correctly.
– √√p.411
PF Encoder Sensor Adjustment Adjusts the position of the PF Encoder Sensor to the PF Scale.
––√ p.414
Rear Sensor AD Adjustment
Acquires AD values of the newly attached Rear Sensor to store them onto the Main
Board as a standard for reading operation of the sensor.
– √√p.415
AID Related
Adjustment
AID Function Check
Checks that the AID Function works correctly.
– √ – p.416
Other
Adjustments
Setting Destination Sets the destination of the Main Board.
√√– p.418
Writing CR/PF Motor Characteristics Writes characteristics of the CR and PF motor to the Main Board.
√ ––p.419
RTC&USB ID Initializes the RTC and writes USB ID.
√ ––p.420
Installing Firmware Installs the firmware for printers, network, color measurement device and take-up reel.
√√– p.421
Input MAC Address Input the MAC address.
√ ––p.424
Input Serial Number Writes and reads the serial number.
√ ––
p.423
Counter Clear Clears the life counter of the periodic replacement parts.
√√– p.427
Cut Position Adjustment Adjusts the cutting position by the Auto Cutter.
– √ – p.425
Ink Holder Adjustment Adjusts the necessary adjustment when replacing the Ink Holder.
√√– p.426
Class Adjustment General Overview
Tool
Page
SP SM MECH