Epson Stylus Pro 9900 - Page 382

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Head Related Adjustments 382
Confidential
5. Select SELF TESTING → Mecha Adjustment → Temporary PG.
6. Press [OK] while [Enter] Un Cap is displayed.
The carriage unit will be unlocked.
7. Open the Front Cover (Middle).
8. Loosen the head tilt lever securing screw shown in Figure 5-36.
9. Move the head tilt lever to up and down and adjust the slant of the Printhead.
10. Tighten the screws that loosened in Step 8.
11. Close the Front Cover (Middle).
12. Print the adjustment pattern again and check the adjustment result.
13. Repeat Step 4 to Step 12 till the adjustment is finished.
14. After finishing the adjustment, press [OK] while [Enter] Cap is displayed to cap
the Printhead. Then, turn the printer OFF and finish the adjustment.
Figure 5-36. Head tilt lever
Top side is slanted to the left
Lever up
CR scan direction
Top side is slanted to the right
Lever down
CR scan direction
Head tilt lever securing screw
Head tilt lever