Epson Stylus Pro 9900 - Page 434

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Tests 434
Confidential
 CR move
1. Select CR move.
2. If the following screen appears, click on the [OK] button.
The Paper Pressing Plate starts operating, then the carriage starts moving.
Figure 5-100. [CR move] Screen
3. Confirm that the carriage operates normally.
If not, follow the instruction below.
Figure 5-101. Carriage Operation Check
C A U T I O N
Perform this check while the mounter is installed on the printer, or
placed on a flat location.
Symptom Remedy
Paper Pressing Plate
does not operate.
Check the installation status of Paper Pressing Plate. (p. 349)
Carriage does not operate
normally.
Check the drive transmission path of the Carriage Motor, and if any
abnormality is found, correct it.
Check the status of the Carriage Motor, and if any abnormality is
found, correct it. (p. 347)
Check the status of the timing belt, and if any abnormality is found,
correct it.
Check the status of the CR HP Sensor, and if any abnormality is
found, correct it. (p. 336)