Epson Stylus Pro 9900 - Page 463

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
Epson Stylus Pro 7700M/7710M (Copy Mode) Copy Mode 463
Confidential
COPY SETTINGS
The following copy settings can be made.
 Copy color (Color
or B&W)
 Quality (Draft
, Normal, Fine)
 Size (enlarge setting and with border/borderless setting)
 Density (0, ± 2)
 Paper type (Plain paper
, Singleweight Matte, Doubleweight Matte, Enhanced
Matte, Premium Glossy 170)
 Auto cut setting (Enable
or Disable)
Figure 7-3. Copy Settings
The “XX -> AUTO” in the size setting enlarges the original image to fit in any of the
following paper sizes or widths depending on the detected size of loaded paper.
 A2 (420 mm)
 B2 (515 mm)
 A1 (594 mm)
 17” (432 mm)
 24” (610 mm)
When any size other than the above is loaded, the original is enlarged to fit in the any
one of the above size closest to the detected size of loaded paper. Therefore, margins
like shown in Figure 7-4 (the gray portion) will appear.
Figure 7-4. Automatically Enlarged Printed Image
C H E C K
P O I N T
 The paper type setting can be made in both the copy mode and
print mode. Changing the setting in the print mode also
changes the setting in the copy mode.
 When copying on paper whose size is not listed in the SIZE
menu, such as 17” and 24” width, “XX -> AUTO” must be
selected in the SIZE setting.
C A U T I O N
When
The copy function does not work with the following settings.
 With the paper width detection disabled in the print mode,
“XX -> AUTO” is specified in the SIZE setting.
 The following settings when using the ADF
• SIZE: “XX -> A0”, “4x6 -> XX”, or “XX -> AUTO
(BANNER)”
• PAPER TYPE: “Premium Glossy 170”
A
Paper Feed Direction