Epson T-B Series Maintenance Manual

T3-B T6-B Maintenance 6. Firmware Update
T-B series Maintenance Manual Rev.1 31
(8) Firmware and data file transfer starts. It takes several minutes to complete.
(9) The following dialog appears.
Click the <Next> button to reboot the Manipulator.
(10) The following dialog appears after the Controller reboot.
Click the <Finish> button.
The firmware upgrade is completed.
Start EPSON RC+ 7.0 and restore the Controller settings.
For details of Controller Backup, refer to “5. Backup and Restore”.
When you install the firmware (Ver.7.4.0.2 or later) on the controller which the firmware
(before Ver.7.4.0.2) has been installed, the following message is displayed.
When the message is displayed, re-install the firmware.

NOTE

Epson T-B Series Specifications

General

Brand	Epson
Model	T-B Series
Category	Robotics
Language	English