Chapter 4 Handling
101
4
Inserting Validation Paper (For Validation Models)
Insert the validation paper in the same way as normal slip paper (See "Inserting Slip Paper" on
page 99.) or follow the steps below.
1
Turn on the printer.
2
Insert the paper with the right paper edge against the right side of the
paper guide at the printer top, and insert it as far as it will go.
3
Insert the paper straight down until the bottom edge of the paper
touches the stopper.
4
When the printer starts feeding the paper, release it immediately.
5
Pull the ejected paper straight up out of the printer.
• Do not insert checks that have clips or staples. This may cause paper jams.
• The paper must be flat, without curls, folds, or wrinkles.
To Next Page
Loading...
