92
Memory Switch Setting Mode
In the memory switch setting mode, you can set the following “memory switches (customized
values),” which are software switches of this printer.
Starting the memory switch setting mode
Follow the steps below to run this mode.
1
Install the roll paper.
2
Close all covers and the receipt unit.
3
While pressing the Feed button, turn the power on. (Keep pressing the
button until the printer starts printing.)
The printer starts printing the current status of the printer.
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
“Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection : 1 second or more”
4
Press the Feed button. (Keep pressing the button until the printer starts
printing.)
The printer starts printing instructions.
• Receipt print density • Transmission speed for serial interface
• Automatic paper reduction • Autocutting at roll paper cover close
• Roll paper width • Interface selection
• Power supply unit capacity • Receipt print speed
• Error control • Power on notice
• NV capacity
(User NV memory, NV graphics memory)
• Command execution during offline
For detailed information about memory switches, see "Setting the Memory Switches/
Receipt Enhancement" on page 65.
With the Ethernet interface, before printing starts, it takes 6 seconds if the IP address is
fixed and 13 seconds if the IP address is obtained with the automatic setting. (It may take
longer, depending on the response time from the host.)
To Next Page
Loading...
