Chapter 5 Replacement of the TM-H6000III
109
5
Replacement of the TM-H6000III
The TM-H6000IV is designed so that it can smoothly replace the TM-H6000III. This chapter
describes precautions for the replacement.
Compatibility
Printing
The printing and character specifications are the same as those of the TM-H6000III. Without
special configurations, the TM-H6000IV prints the same results as the TM-H6000III prints.
Number of Head Energizing Parts for Receipt Printing
For the TM-H6000IV, the initial setting of the number of head energizing parts is “One-part
energizing.” You can change the setting with the customized value (See "Setting the Memory
Switches/Receipt Enhancement" on page 65.); however it does not usually need to be changed.
Printable Area
The printable area of the TM-H6000IV is the same as that of the TM-H6000III except for the
bottom margin of endorsement printing.
Cutting Method
The TM-H6000IV uses the partial cutting method (cutting with one point in left edge left uncut)
as does the TM-H6000III.
TM-H6000IV TM-H6000III
Number of head energizing part
• One-part energizing
• Two-part energizing
• Four-part energizing
Not changeable
TM-H6000IV TM-H6000III
Bottom margin
22 mm
Unrestricted
To Next Page
Loading...
