86
Starting the status print and test print on the roll paper
Follow the steps below to start a status print and test print on the roll paper.
1
Install the roll paper.
2
Close all covers and the receipt unit.
3
While pressing the Feed button, turn on the printer. (Keep pressing the
button until the printer starts printing.)
The printer starts printing the current status of the printer on the roll paper.
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
“Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection : 1 seco
nd or more”
4
To start the test print, press the Feed button (less than 1 second).
The printer prints a rolling pattern on the roll paper, using only the built-in character set.
After printing the following message, the printer is initialized and returned to the normal mode.
“*** completed***”
With the Ethernet interface, before printing starts, it takes 6 seconds if the IP address is
fixed and 13 seconds if the IP address is obtained with the automatic setting. (It may take
longer, depending on the response time from the host.)
If you select the mode selection, see "NV Graphics Print Mode" on page 90, "Receipt
Enhancement Information Print Mode" on page 92, or "Memory Switch Setting Mode" on
page 93.
To Next Page
Loading...
