EasyManua.ls Logo

Epson TM-P80

Epson TM-P80
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3 Application Development Information
75
3
Setting the memory switch
Follow the steps below to run this mode.
Enter the memory switch setting mode.
1. Check that the roll paper is set and that the printer is turned off.
2. While pressing the Feed button, turn on the printer. Keep pressing the Feed button until the printer
starts printing.
3. When the printer finishes printing the printer status, press the Feed button. Keep pressing the Feed
button until the printer starts printing.
4. Press the Feed button 2 times.
5. Then press the Feed button. Keep pressing the Feed button until the printer starts printing.
The printer starts printing instructions for settings. Follow the instructions.
Select the setting item
Select the setting item by the number of times the Feed button is pressed as follows.
When the Feed button is not pressed (0 times) or it is pressed more than 13 times, this mode finishes.
1: Print Current Settings
2: Print Density
3: Automatic Paper Reduction
4: Interface Selection
5: USB Interface Settings
6: Printing Speed
7: NV Capacity
8:
Command Execution (Offline)
9: Transmission of status
information
10:Buzzer sounds
11:Auto power off
12:Paper Position at Power On
13:Column Emulation
When the button is pressed
less than or more than
shown on the left, the
setting has not been
changed.
Set the conditions
You can make settings for each condition per setting item by the number of times the Feed button is
pressed.
Print Current Settings
Print Density (page 76)
Automatic Paper Reduction (page 76)
Interface Selection (page 76)
USB Interface Settings (page 76)
Printing Speed (page 77)
NV Capacity (page 77)
Command Execution (page 77)
Transmission of status information (page 77)
Buzzer sounds (page 78)
Auto power off (page 78)
Paper Position at Power On (page 78)
Column Emulation (page 78)
Finish the memory switch setting mode
Turn off the printer. Print out the new settings and save them to the NV memory. Software is reset, and the
printer is ready to print.

Table of Contents

Other manuals for Epson TM-P80

Related product manuals