15 14
Command Name
GS ( C
Edit user NV memory
GS ( D
Enable/disable real-time command
GS ( E
User setup commands
GS I
Transmit printer ID
GS V
Feed paper to cutting position
GS a
Enable/disable Automatic Status Back (ASB)
GS r
Transmit status
3.1.2 Obsolete commands
The commands listed below in the first column are defined as “Obsolete commands” in the ESC/POS
command system. This printer supports both upward-compatible commands and obsolete
commands. However, the upward-compatible commands are recommended to use.
Deprecated command Upward-compatible command
ESC i: Partial cut (one point left uncut) GS V
ESC m: Partial cut (three point left uncut) GS V
ESC u: Transmit peripheral device status GS r
ESC v: Transmit paper senor status GS r
NOTE: “Obsolete commands” are commands that are supported by legacy models; however it is
recommended to replace them with upward-compatible commands, because they will not be
supported in the future products.
To Next Page
Loading...
