6.5 Obsolete Commands
ESC i [obsolete command]
GS V, which is the upward-compatible command replacing ESC i, is recommended to use, since ESC i
is an obsolete command in the ESC/POS command system.
[Name] Partial cut (one point left uncut)
[Format] ASCII ESC i
Hex 1B 69
Decimal 27 105
[Description] • Executes a partial cut of the roll paper.
[Notes] • Type of cutting is set according to the installation position of the autocutter.
• Partial cut (one point left uncut)
• Full cut
ESC m [obsolete command]
GS V, which is the upward-compatible command replacing ESC m, is recommended to use, since
ESC m is an obsolete command in the ESC/POS command system.
[Name] Partial cut (three points left uncut)
[Format] ASCII ESC m
Hex 1B 6D
Decimal 27 109
[Description] • Executes a partial cut of the roll paper.
[Notes] • Type of cutting is set with the installation position of the autocutter.
• Partial cut (one point left uncut)
• Full cut
To Next Page
Loading...
