WF-C20590 Installation Guide
Unpacking 8
8. Have one worker stand at the back of the printer to support it, and two workers
stand at each of the front corners of the printer.
9. While holding each front corner of the printer, the two workers should tilt the
printer back while the fourth worker removes the foam cushioning material and
the plastic sheet under the printer from the caster.
10. Gently lower the printer back down to the pallet.
11. Place the wheel stoppers on each front caster.
To keep the printer from moving when unpacking, do the
following:
Insert the wheel stoppers from the side to the advancing
direction of the caster.
Make sure the wheel stoppers are completely secured.
To Next Page
Loading...
Need help?
General
