Getting Started
• ASI TS Rate - This is the transport stream bit rate for the ASI output. If this field
cannot be edited the ASI output is a mirror and the bit rate is determined by the
main output.
3.20.1.4.3 Service Configuration
The Simplified View provides the ability to modify the configuration of the Main
output Transport Stream. Service Information, PID values, Carrier ID information (for
Satellite Modulator Output), encryption mode and key (RAS or BISS if licensed for a
Satellite Modulator output or BISS if licensed for ASI or IP outputs) are configurable,
as well as the ability to simply add or remove available audio and ANC components
that have been included in the service when initially configured.
Note: Only a single BISS key is supported from the Simplified View, so the same
key will be applied when BISS is enabled on multiple outputs. If different
keys are required then the Advanced View must be used.
Remove Component
Add Component
Display more Video and Audio configurable properties
Edit PID
Figure 3.33 Simplified View - Modifying Component Configuration
Note: The number of audio components available is determined by the number of
audio components included in the service (up to a maximum of 8). If more
are required, the user should go to the advanced view and add the required
audio components.
To Next Page
Loading...