Front Panel Control
Transport Stream ID
The label to identify the current Transport Stream from any other
multiplex within a network.
Network Name The network name as used in the NIT.
Network ID The network ID as used in the NIT.
Mode CBR, VBR.
PSI-SI Level
Off, On (PAT, PMT only), On (PAT/PMT/SDT/CAT/NIT). Sets which
tables are inserted into the Transport Stream.
Send Extended NIT (SIRG)
On, Off. Determines whether Carrier ID is to be inserted in the NIT.
Available only when the PSI-SI Level is set so that NIT is generated.
PMT Repetition Period The repetition interval of the PMT table expressed in ms.
Transport Stream Bit Rate The Bit Rate of the Transport Stream.
Bit Rate Tracking Mode
Off, Maximise video. Enables or disables Bit Rate tracking for the
current Transport Stream.
Auto Enable
If set to true, it automatically re-enables the Transport Streams
when all the specified error conditions are cleared.
Auto Disable
Never, Audio Lost, Video Lost, Any Upstream CRITICAL Alarm, Any
CRITICAL alarm. Disables the output when the set condition is met.
The Transport Stream can be set to be re-enabled at the Auto
Disable option.
4.4.1.7 Alarms Menu
The Alarms Menu displays the alarm settings available on the unit.
4.4.1.8 Shortcuts Menu
The Shortcuts menu displays the shortcuts available on the unit.
4.4.1.9 Unit Config Menu
The Unit Config Menu displays the device settings. The menu options are shown in
Table 4.11.
Table 4.11 Unit Config Menu
Unit Config
Remote Control Setup
IP Address The IP address of the unit for upgrade or web control.
Subnet Mask The subnet mask associated to the IP address set.
Gateway Address The gateway through which the unit can be accessed.
Display Setup
Video Monitor Input Provides list of available sources
Video Monitor Parameters
Video Monitor Brightness 0 – 8 Adjusts the brightness of the monitor
To Next Page
Loading...