Ericsson AVP 1000 - Configuring Service Level Remux; How to Set up Remux

Getting Started
EN/LZT 790 0023/1 R16A
3-23
3.8.6 How to Set Up Remux
Services from a Transport Stream can be remuxed from an ASI input to any output
that can produce a Transport Stream.
3.8.6.1 Configuring Service Level Remux
In order to remux a service from an input to an output, first ensure there is a
Transport Stream already configured with an existing service on the output you wish
to add the remuxed service to. Once the Transport Stream has been created, drag
one or more required services from their input to the target Transport Stream.
Figure 3.12 Drag and Drop Service from ASI input to Output Transport Stream
Note: The Remux Configuration wizard will start when the service has been
dropped onto the Transport Stream.
The Remux Configuration wizard will prompt you to select which components you
want to remux. By default, all components from all services dragged across will be
selected. Once you have confirmed the components you want to remux, click on
Finish.