Getting Started
Figure 3.37 Switching between Simplified View and Advanced Configuration GUI
3.20.1.5 Simplified View Limitations
The following is a list of limitations which should be observed when using the
Simplified View.
1. The Advanced View and Simplified View should not be open at the same time.
This can result in discrepancies in reported values. The link should be used to
switch between views when necessary.
2. At least one output MUST be configured with a Transport Stream containing a
service with video and audio components. This means that:
- The Transport Stream must be set online.
- Only a single service with one video and up to eight audio components and
an ANC component is supported on the Simplified View. Additional services
in the TS will not be presented on the Simplified View.
- The first service must be configured to use the first VCM fitted in a multiple
VCM chassis.
- All required components must be initially added to the service using the
Advanced pages.
- Additional services and components need to be controlled using the
Advanced View.
- Any VBI requirements must be configured using the Advanced View.
3. Only one Transport Stream (the first Transport Stream of the main output) is
supported in the Simplified View. Additional Transport Streams may be
configured, but need to be accessed using the Advanced View.
To Next Page
Loading...