Ericsson AVP 1000 - Setting up BISS from the Front Panel

Getting Started
EN/LZT 790 0023/1 R16A
3-47
Figure 3.26 Selection of Components to be Scrambled Using BISS
8. Selecting an individual component to be scrambled using BISS is performed on
the Component tab of the Properties of that output component.
Figure 3.27 Scrambling Selection of an Individual Component
3.17.4 Setting Up BISS from the Front Panel
To set up BISS encryption service from the front panel:
Note: When a value needs to be changed using the front panel, the existing value
needs to be deleted using the Del key, before a new value can be entered
using the keypad.
1. If you want to use BISS Mode-E navigate to Advanced>System>Base Unit on
the front panel and set the BISS injected ID (14 hexadecimal characters)
using the keypad.
2. Navigate to the required output service (Output > Transport Stream ID >
Service List > Service n and scroll down to BISS Key. Enter the required key
location (1 to 31).