Ericsson AVP 1000 - Configuring Option Cards Using the Service Configuration Page; Disabling a Transport Stream if a Critical Alarm or an Upstream Critical Alarm Is Raised; Providing more Space for Configuration Items in the Properties Widget; Reserving Bandwidth for Transport Streams

Web GUI Control
5-46
EN/LZT 790 0023/1 R16A
5.5.2.10 Disabling a Transport Stream if a Critical Alarm or an Upstream Critical Alarm
is Raised
An upstream CRITICAL alarm is an alarm raised by a module that has direct
influence on the Transport Stream.
To disable the output when a critical alarm or an upstream CRITICAL alarm is
raised, do the following:
1. In the Outputs widget, select the Transport Stream you want to disable when a
CRITICAL alarm or an upstream CRITICAL alarm is raised.
2. In the Properties widget, set the Auto Disable to Any Critical Alarm or Any
Upstream CRITICAL Alarm.
5.5.2.11 Restoring a Transport Stream if the Auto Disable Condition is not Met
To restore the output when the Auto Disable condition is cleared, do the following:
1. In the Outputs widget, select the Transport Stream whose Online state you
want to restore.
2. In the Properties widget, set the Auto Enable to true.
5.5.2.12 Reserving Bandwidth for Transport Streams
Bandwidth reservation allows the user to reserve a configurable amount of
bandwidth in the output Transport Streams. The reserved amount will always be
preserved even if bit rate tracking is enabled. To specify the amount of bandwidth to
reserve, do the following:
1. Select a Transport Stream in the Outputs widget.
2. In the Properties widget, set the Reserved Bit Rate to the required value.
5.5.2.13 Providing More Space for Configuration Items in the Properties Widget
When a service has many components of different types, the Properties widget
might get crowded with accordion panels that belong to the different components.
To preserve space, some of the components (based on their types) can be hidden.
To show or hide a component type, do the following:
1. Select a Transport Stream in the Outputs widget.
2. In the Properties widget, choose View > Visibility Control > Show x or View >
Visibility Control > Hide y, where x and y is the type you want to show or hide.
5.5.3 Configuring Option Cards Using the Service Configuration Page
This section gives the tables of parameters available for configuring the option cards
using the Service Configuration Web Page.