Getting Started
Figure 3.29 Simplified View Web Page – Satellite Modulator, IP and ASI Outputs
Configured (IP and ASI Mirrored)
3.20.1.3 Multiple Outputs
Multiple outputs are supported in the Simplified view, but with some limitations.
When multiple outputs are configured (either mirrored or independent), the
Transport/Service and Properties panels are only those included in the main output,
which is defined in the following priority order:
I. SatMod (if available and configured),
II. IP (if no SatMod output and IP is configured)
III. ASI (if configured and no other output is configured).
It is not possible to select which output these panels relate to. When components
are common across the outputs changes will affect the common outputs, but this will
not necessarily be indicated on the Simplified View.
Note: The immediate action header banner at the top of the page shows the
configured outputs in this order, so as a general rule of thumb is that the
Transport/Service and Properties panels relate to the first output in the
header banner.
To Next Page
Loading...