Preventive Maintenance and Fault-finding
Note: Configurations saved from units running previous releases of code may not
be fully compatible with newer code releases. A configuration converter tool
is available to convert these configurations.
8.9 Remote Server Logging
8.9.1 Overview
The remote server logging feature enables an external log server to be used to
capture selective logs from the AVP unit. Four different categories of system log
entries may be selected and delivered to a designated remote server. The four
categories are:
• Logging messages related to alarms.
• Logging messages related to ESAM.
• Logging messages related to SCTE-35.
• User configuration changes made to the system.
8.9.2 Configuring Remote Server Logging
Enabling Remote Server Logging
To enable remote server logging:
1. Navigate to the Device Configuration > Advanced Setup page.
2. In the Advanced Video Processor Settings widget on the left-hand side of the
screen, click on the Base Unit folder to open the folder tree.
3. Click on the Remote Server Logging folder to display the relevant properties in
the Properties widget on the right-hand side of the screen.
4. Enter the Remote Server IP Address and select the log options required (see
Figure 8.1).
5. Click on the Apply All button to accept the new properties.
Disabling Remote Server Logging
To disable remote server logging:
1. Navigate to the Device Configuration > Advanced Setup page.
2. In the Advanced Video Processor Settings widget on the left-hand side of the
screen, click on the Base Unit folder to open the folder tree.
3. Click on the Remote Server Logging folder to display the relevant properties in
the Properties widget on the right-hand side of the screen.
To Next Page
Loading...