Installing the Equipment
GPI Data Input Connector (Not supported in this release)
The Data Input provides an asynchronous serial data communications interface
conforming to the IEC-232 (RS-232) standard.
The DATA IN connector is a 9-way D-type female connector on the rear panel. The
pin connections are shown in Table 2.29.
Table 2.29 Data Input Connector Pin-out
Remote (DTE) Male Option Card (DTE) Female
Signal Name Pin Signal Direction Pin Signal Name
1 1 Not Connected
Received Data 2 2 Received Data
Transmit Data 3 3 Transmit Data
4 4 Not Connected
Signal Ground 5 5 Signal Ground
6 6 Not Connected
7 7 Not Connected
8 8 Not Connected
9 9 Not Connected
2.3.10 Mini USB Connector
The mini USB connector on the front panel of the AVP chassis provides an interface
for remote web access and update from a computer, and for saving or exporting
configurations to, and loading or importing configurations from a USB stick.
Figure 2.7 Mini USB Connector
For details on using the mini USB connector, see Chapter 4, Front Panel Control.
To Next Page
Loading...