5.5.2.8 Cloning Transport Streams
Transport Stream cloning allows the user to create a mirror of an existing Transport
Stream. Mirrored Transport Streams are only references to the original one. Thus,
any change in the original Transport Stream will be automatically applied in the
mirrored Transport Stream.
Note: No external Transport Streams, services, or components will show up under
a mirrored Transport Stream in the Outputs widget of the Service
Configuration page. Furthermore, when a mirrored Transport Stream is
selected, the Properties widget will display a link to the original one, and
will not display any parameters.
Although the content of the mirrored and the original Transport Stream is
the same, the physical output streams will not be identical bit-by-bit. This is
due to the mechanism the Transport Streams are played out through the
different outputs.
To create a clone of an existing Transport Stream, do the following:
1. In the Outputs widget, select the Transport Stream you want to clone.
2. Select Copy from the Edit menu on the menu bar of the Outputs widget.
3. Select the output you want to insert the clone to.
4. Choose Edit > Paste as Mirror. The Transport Stream will be pasted as a
mirror at the selected Transport Stream.
5.5.2.9 Disabling a Transport Stream if Audio or Video Lock is Lost
To disable the output when the input lock is lost for a component in a Transport
Stream, do the following:
1. In the Outputs widget, select the Transport Stream you want to disable when
the lock of any of its components is lost.
2. In the Properties widget, set the Auto Disable to Audio Lost, Video Lost, or
Audio or Video Lost depending on what shall trigger turning the output off.
3. In the Outputs widget, select the video component whose lock state shall
influence the Transport Stream output.
4. In the Properties widget, click on the Input tab, and set the Output On Video
Loss to No PID.
5. In the Outputs widget, select the audio component whose lock state shall
influence the Transport Stream output.
6. In the Properties widget, click on the Input tab, and set the Output On Audio
Loss to No PID.
To Next Page
Loading...