Ericsson AVP 1000 - Line up Menu; Modulation Parameters Menu

Front Panel Control
4-12
EN/LZT 790 0023/1 R16A
Device Config <n>:
<name>
The list of configurations stored on the USB stick. The configurations to be exported can be
selected by pressing the Select button on the keypad.
Device Config <n>: <name> Exports one particular configuration to USB stick.
1
Visible only when a USB drive is detected.
4.4.1.2 Line Up Menu
The Line Up Menu displays the Satellite modulator line up settings. The menu
options are shown in Table 4.6.
Table 4.6 Line Up Menu
Line Up
Output State
On (Nominal Power), On (Reduced Power), Off. Turns off or turns on the carrier signal with the selected
power as set by the relevant parameter.
Nominal L-Band Power
1
-40 – 5 dBm
Reduced L-Band Power
1
Nominal IF Power
2
-30 – 5 dBm
Reduced IF Power
2
Modulation State On, Off
L-Band Frequency
1,3
950 – 2150 MHz. The center frequency of the signal output through the L-Band output.
IF Frequency
2,3
50 – 180 MHz. The center frequency of the signal output through the IF output.
Uplink Frequency
4
The frequency the signal is converted to by the up-converter fed from the Voyager II. Its valid range
changes depending upon other parameters.
1 Applies to L-Band output only.
2 Applies to IF output only.
3 Accessible if Frequency Input Mode is set to other than Uplink Frequency in the Modulation Parameters menu.
4 Accessible if Uplink Frequency is set for Frequency Input Mode in the Modulation Parameters menu.
4.4.1.3 Modulation Parameters Menu
The Modulation Parameters Menu displays the Satellite Modulation settings. The
menu options are shown in Table 4.7.
Table 4.7 Modulation Parameters Menu
Modulation Parameters
Modulation State
On, Off. The values are read only here and can only be changed in the Line Up or in the Advanced/Satellite
Modulator Option Card/Output Parameters menu. The state is also reflected by icons, see Front Panel Screens.
Modulation
Standard
DVB-S, DVB-DSNG, DVB-S2, DVB-S2X. The used modulation standards are defined by ETSI EN 300 421, ETSI
301 210 or ETSI EN 302 307, respectively.
Modulation
QPSK, 8PSK, 8PSK-L 16QAM, 16APSK, 16APSK-L, 32APSK, 32APSK-L, 64APSK and 64APSK-L. The availability
of the constellations used for modulating the carrier is subject to the availability of licenses and the value set for the
Modulation Standard parameter.