Getting Started
Figure 3.10 Configuring a Pass-thru Transport Stream
The Properties widget shows that a Pass-thru Transport Stream has been
configured and there are no configurable parameters.
Figure 3.11 Properties Panel view of Pass-thru Transport Stream
3.8.5.1.1 Configuring a Pass-thru TS From the Front Panel
To configure a Transport Stream Pass-thru on the front panel, select Add Existing
Transport Stream in the menu of the appropriate output, and choose the required
incoming Transport Stream from the list.
3.8.5.1.2 TS Pass-thru Limitations
If the bit rate of an input stream is too high for the output to handle, the output is
unusable, and alarms for too high data rate or buffer overflow are issued.
To Next Page
Loading...