Front Panel Control
IP Redundancy Mode
Active-Active, Active-Standby. Describes the behavior of the spare
interfaces.
Active Interface
Read only parameter. In Active - Active redundancy mode both
interfaces are active.
Line Speed Auto, 100 Mpbs, 1 Gbps. The transmission speed of the link.
Duplex Mode
Auto, Full Duplex, Half Duplex. Determines whether data are to be
transmitted and received in a time divided manner (Half Duplex) or
transmission and reception can happen at the same time over the
same link (Full Duplex). Auto is for automatic configuration.
Default Virtual MAC Address Virtual MAC address assigned to the Data Interface Group.
IP Address The IP address associated with the interface group.
Subnet Mask The subnet mask associated with the interface group.
Gateway Address The gateway address associated with the interface group.
IGMP mode Selection IGMP v2, IGMP v3
Physical Data Interface <k>
The physical data interface labeled as Ge <k> of the current data
interface group.
Default MAC Address The hardware address of the Ge <k> interface.
Link Status
Link Down, Link Up. The status of the current physical data
interface.
Link Up Time
The time in days, hours, minutes and seconds the link is
established. Read only parameter.
TX Packets Packets transmitted since the link is up.
RX Packets Packets received since the link is up.
IP Address The IP address of the physical data interface.
Add New Transport Stream Creates a new Transport Stream for the current output.
Add Existing Transport Stream
Creates a copy of an existing Transport Stream for the current
output.
<l> The list of the Transport Streams to copy to the current output.
Transport Stream ID <id> Selects the Transport Stream with ID <id> to modify its parameters.
Service List The list of services in the current Transport Stream.
Add Service Adds a new service to the current Transport Stream.
Service <name>
Selects the service with <name> already added to the current
Transport Stream.
Component List List of components in the current service.
Add Component Adds a new component to the current service.
<Component name> on <pid>
Selects the component with <component name>
and <pid> already
added to the current service.
Elementary Stream
The elementary stream associated with the component produced by
one of the CE VCM modules in the unit.
To Next Page
Loading...