Ericsson AVP 1000 - Page 145

Front Panel Control
EN/LZT 790 0023/1 R16A
4-29
Reflex TTL
The time to live value to be applied to all Reflex v5 messages
transmitted from the current unit.
Set Rate Timeout Period
The maximum number of video frames between set rate messages. If
exceeded, Set Rate Message Timeout Alarm is triggered.
Output Stream List
Lists the output reflex streams. Empty in this release as Reflex is not
supported.
MGP Support
Supported MGP Version The MGP version supported by the unit. Read only parameter.
MGP Mode
Off, Module Level, Unit Level. Determines if MGP is enabled or not, or
if it is enabled, then the unit is controlled as a whole or on a module
level basis.
Transmission Interval Period for steady-state transmission of MSM packets in units of ms.
R0 Playout Period
Duration of the MSM burst emitted on entering MGP state R0 in units
of ms.
S1 Playout Period
Duration of the MSM burst emitted on entering MGP state S1 in units
of ms.
Control Contact Timeout
Period of time in ms the system waits before assuming loss of contact
with the control system after the control link goes down.
MSM Destination Port UDP port for sending MGP packets.
MGP Settings
1 1
Only available when MGP is enabled
MSM Multicast Address The destination IP Address of the MSM packets.
MGP State The current state of the MGP implementation.
MGP Spares
Spare Device Configuration Selects a spare device to set up its parameters.
Spare IP Address
The IP address of another unit that is acting as a spare for this
unit/service.
Vlan Tags
Output <n>: Data Port <m> - Data Port <k> Selects output <n> for adjusting its VLAN settings.
Add Vlan tag Adds a new VLAN tag to the current output.
Vlan ID: <id>
The ID associated with the VLAN tag. Allows the user to change the
ID.
Vlan ID (Create) Modifies the VLAN ID for the current tag.
Vlan IP Assigns an IP address to the VLAN.
Vlan Netmask Specifies the network mask for the current VLAN.
Vlan Gateway Specifies the gateway address for the current VLAN.
SNMP
System Contact Contact to the team providing support for this unit.
System Name The name to identify the current unit.