Ericsson AVP 1000 - Page 212

Web GUI Control
5-36
EN/LZT 790 0023/1 R16A
Parameter Values Description
Modulation
QPSK
1,2,3,4
, 8PSK
1,2,4
, 8PSK-L
4
,16QAM
2
,
16APSK
1,4
, 16APSK-L
4
, 32APSK
1,4,
,32APSK-
L
4
, 64APSK
4
and 64APSK-L
4
The modulation mode and order used for the transmission.
Modulation for TS2 QPSK, 8PSK
1,2
, 16QAM
2
, 16APSK
1
, 32APSK
1
Same as above for the 2nd Transport Stream in VCM mode.
Pilots
1,4
Off, On
Toggles the insertion of pilot symbols into the transmitted
signal on and off.
Pilots
1
for TS2 Off, On Same as above for the 2nd Transport Stream in VCM mode.
NCR Stamping PID 0 - 8191
The PID used for packets transmitting Network Clock
Reference.
Symbol Mapping
Mode
Peak Power, Mean Power Specifies what to use for power normalization.
PL Scrambling
Sequence Number
1,4
0 to 26141 The sequence number used for physical layer scrambling.
Symbol Rate
1.000000 Msymbol/s to 45.000000 Msymbol/s
(standard)
0.132000 Msymbol/s to 66.000000 Msymbol/s
(with VOY/SWO/HSYM license - extended
range)
The symbol rate used for modulation.
Roll-off Factor 5, 10, 15, 20, 25, 35 % The roll-off factor of the filter used for pulse shaping
1 Applies to DVB-S2
2 Applies to DVB-DSNG
3 Applies to DVB-S
4 Applies to DVB-S2X
5.4.4.7.4 Satellite Modulator Output Configuration
The following parameters are available through the Advanced Setup tab of the
Device Configuration page under Slots > Slot <n> - Satellite Modulator Option
Card > Satellite Modulator > Output Parameters or on the Output Parameters
tab in the Properties widget of the Service Configuration page if one of the
Satellite Modulator Output Stream is selected in the Outputs widget. The same
parameters can be accessed through the Advanced/Satellite Modulator/Output
Parameters menu on the front panel.
Table 5.10 Satellite Modulator Output Configuration Parameters
Parameter Values Description
RF Carrier ID State On, Off Enables DVB-CID on the modulator output.
Output Select L-band, IF Specifies which output to use.
Output State
On (Reduced Power), On (Nominal Power),
Off
Turns the output of the Satellite Modulator on at the specified
power level or off. Note that to enable the output, the Transport
Stream through the satellite modulator output has to be set to
Online Setmode state.
L-Band Output
Frequency Input Mode L-Band Frequency, Uplink Frequency
The mode how the frequency is treated. For L-Band
Frequency the RF center frequency of the respective output is
directly entered. For Uplink Frequency, the RF center
frequency is calculated from the Uplink Frequency and the Up-
converter Frequency.