Parameter Values Description
Default Servicename The default service name to be used.
Broadcaster ID Source No, Input, Default
Indicates if the Broadcaster ID is derived from the input,
the default or is invalid.
Broadcaster ID
The Broadcaster ID that is currently being inserted into the
output stream.
Generic ANC
Generic ANC
Extraction
Off, On
Controls whether Generic ANC is extracted from the SDI
stream or not as per SMPTE 2038-2008.
Max ANC Bit Rate 100 to 2000 kbps The maximum data rate of the Generic ANC data output.
Field 1
VBI Line 9 - VBI Line
22
Off, Closed Caption
Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, Closed Caption for closed caption information.
Visible for 480i (525-line) input streams.
VBI Line 6 - VBI Line
23
Off, VITC, WSS, WSS-AFD, Teletext System B
Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, VITC for Time Code, WSS for Wide Screen
Signaling, WSS-AFD for Active Format Detection and
Teletext System B for Teletext. Visible for 576i (625-line)
input streams.
Field 2
VBI Line 272 - VBI
Line 285
Off, Closed Caption
Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, Closed Caption for closed caption information.
Visible for 480i (525-line) input streams.
VBI Line 319 - VBI
Line 336
Off, VITC, WSS, WSS-AFD, Teletext System B
Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, VITC for Time Code, WSS for Wide Screen
Signalling, WSS-AFD for Active Format Detection and
Teletext System B for Teletext.
Input Detection
The CE-a VCM supports video input detection as described in Chapter 3, Getting
Started: How to Configure and Use Input Detection.
5.5.3.1.2 Audio Stream Configuration
Audio Input
The parameters listed in the table below are available on the Input tab of the Properties
widget on the Service Configuration page when an audio component is selected in the
Outputs widget. The same parameters can be accessed through the Advanced/CE-
a/Audio Module/Audio <n>/Input menu on the front panel.
To Next Page
Loading...