Parameter Values Description
Output On Audio Loss No PID, Silence
Specifies the action to take when input is Lost. No PID is
for dropping the audio PID from the stream, Silence is for
encode silence.
When No PID is selected, the reference to the PID is not
removed from the Program Map Table, so a Transport
Stream analyzer will indicate a ghost PID in the output
Transport Stream.
Audio Encoding
The following parameters are available on the Encode tab of the Properties widget
on the Service Configuration page when an audio component is selected in the
Outputs widget. The same parameters can be accessed through the
Advanced/CE-a J2K/Audio Module/Audio <n>/Encode menu on the front panel.
Table 5.42 Audio Encoding Standards
Parameter Options Description
Coding Standard Pass-thru Pass-thru of the input
Table 5.43 Pass-thru Parameters
Parameter Values Description
Embedded PCR On, Off
Controls whether PCR is to be embedded in the audio
PES.
Au Information Cont Off, AU Info
Controls the insertion of private data in the adaptation unit
of the audio access units (AU). AU Info is defined in ETSI
TR 101 154. Only AU_PTS is present for audio.
Advanced
Lip Sync Offset -500 to 500 ms
Configures a delay to the audio to improve A/V
synchronization.
Gain -6 to 6dB Sets the gain in dB for the audio stream.
Language The language of the stream.
User Language 1
A custom three-character language code when User
Language 1 is set the Language field.
User Language 2
A custom three-character language code when User
Language 2 is set in the Language field.
Audio Component
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when an audio component is selected in
the Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/<component name> menu on the front panel.
To Next Page
Loading...