Web GUI Control
Parameter Values Description
Original Off, On Sets the original flag in the elementary stream header.
PES Packet Per GOP, Picture
Determines how PES packets shall be generated. The
Picture option is only available if MPEG 2 encoding is
used.
AU Information Ctrl Off, RAI, RAI and AU Info
Controls insertion of Private Data in the TS Adaptation
Field for video Access Units (AU). This can be: Random
Access Indicator (RAI), ETSI 101 154 (AU info), Time
Code (TC) and Additional Info (Encoding info and
BroadcasterID).
Elementary Stream
Stuffing
Off, On
Control for the Elementary stream level to maintain the
configured bit rate.
AR Signaling Output
Control
Off, AFD Only, AFD and Bar Data
Controls what Aspect Ratio signaling will be put into video
user_data. AFD sources are: SMPTE 2016, Video Index,
WSS-AFD/WSS, user set Aspect Ratio. Bar Data is only
SMPTE 2016.
AR Signalling Location Sequence Hdr, Picture Hdr, Seq And Pic Hdrs
Specifies which header shall contain the aspect ratio
signaling information.
TC Output Location SeqHdr, SeqAndPicHdr, Off, SEIMsg
Determines the locations used to transmit Time code
information in the stream. Time code can be carried by the
sequence header, the sequence and picture headers for
MPEG-2 or a SEI message for H.264.
Video Component
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when a video component is selected in
the Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/Slot <x> Video Stream on PID <y> menu on the front
panel.
Table 5.51 Video Component Parameters
Parameter Values Description
PID 32 to 8190 Sets the packet identifier associated with the component.
Bit Rate Weighting Fixed, Minimum, 2 to 20
Specifies the weight associated to the component in the
Bit Rate Tracking algorithm.
Master TS Off, On Sets the master Transport Stream for the component..
Vertical Blanking Interval / Ancillary Data
The following parameters are available on the VBI tab of the Properties widget on
the Service Configuration page when a video stream is selected in the Outputs
widget. The same parameters can be accessed through the Advanced/CE-
x/Video/Video 1/Input/VBI Extraction menu on the front panel.
To Next Page
Loading...