Getting Started
Figure 3.7 Service Configuration Web Page – Adding a Component
9. Release the left mouse button. The component is added to the newly created
service and its parameters are shown on separate tabs in the Video
Component accordion panel of the Properties widget.
10. Adjust the video properties as required.
11. Add all the required components (audio, VBI...) from the Inputs widget to the
Transport Stream as above. Adjust the component parameters in the respective
accordion panel of the Properties widget.
Note: To identify the source of a certain component in the Outputs widget, click
on the component. The source of the component is highlighted in grey in the
Inputs widget. You may have to scroll in the Inputs widget to actually see
the highlighted component.
12. Modifying the same parameter for different items of the same type (for instance,
the bit rate of two or more audio components) can be carried out by selecting all
the items, navigating to the property to be changed, and changing the value. If
the values for the selected items are different, then the string [Mixed] is shown
in the respective field.
13. If you want to create another service or Transport Stream, repeat the steps
above.
14. Turn the Transport Streams online by selecting the Transport Stream and
clicking on the Online button in the Properties widget.
Note: Turning the Transport Stream online does not turn the modulator output on.
The additional steps below are needed.
15. The Satellite Modulator output and modulation parameters can be configured
from the Service Configuration>Satellite Modulator>Properties tabs. For the
output to be transmitted, in addition to the TS being set Online, the output state
To Next Page
Loading...