Ericsson AVP 1000 - Page 73

Getting Started
EN/LZT 790 0023/1 R16A
3-31
Input Options
Table 3.8 Input Options Parameters
Parameters Values Description
Input Detection
Off, Auto Detect and Report, Auto Detect and
Configure Video Profile Only, Auto Detect and
Restore Saved Config
Specifies what to do when the input video format has been
changed.
Detected Video
Standard
Not Detected, SD 567i25, SD 480i29.97, HD
720p50, HD 720p59.94, HD 1080i25, HD
1080i29.97
The detected video standard if Input Detection is set to
other than Off. If the format is not detected or Input
Detection is set to Off, it is set to Not Detected. Read only
parameter.
Select Configs to be
loaded on input video
detection
SD 567i25,
SD 480i29.97,
HD 720p50,
HD 720p59.94,
HD 1080i25,
HD 1080i29.97,
3G 1080p50,
3G 1080p59.94
No Action
Config n
Only available when Auto Detect and Restore Saved
Config is selected.
For each input format a drop down box will display all
available stored configs
Encode Options
Table 3.9 Encode Options Parameters
Parameters Values Description
Profile for SD
Profile Off,
Available profiles depend on card type and
licenses
The profile to set when a change to an SD format has been
detected. Available only if Input Detection is set to Auto
Detect and Configure.
Profile for HD
Profile Off,
Available profiles depend on card type and
licenses
The profile to set when a change to an HD format has been
detected. Available only if Input Detection is set to Auto
Detect and Configure
Profile for 3G Profile Off
Available profiles depend on card type and
licenses
The profile to set when a change to an 3G format has been
detected. Available only if Input Detection is set to Auto
Detect and Configure
Input Detection is Set to Off
If Input Detection is turned off, the input video format is not monitored by the VCM.
No action is taken when there is a change in the format of the incoming native video
through the SDI/HD-SDI input, other than that specified by the output on video loss
parameter.
Input Detection is Set to Auto Detect and Report
If Input Detection is set to Auto Detect and Report, a video lock alarm is raised if the
video lock is lost on the SDI/HD-SDI input and the output on video loss setting will
apply.