SmartEdge 600 Router Hardware Guide
Table 155 SAS Connector Pin Assignments
Pin # Signal Name Signal Type Pin # Signal Name Signal Type
S1 Ground for SAS
Primary
Ground S8 Ground for SAS
Secondary
Ground
S2 SAS Primary TP+ Output S9 SAS Secondary TS+ Output
S3 SAS Primary TP- Output S10 SAS Secondary TS- Output
S4 Ground for SAS
Primary
Ground S11 Ground for SAS
Secondary
Ground
S5 SAS Primary RP- Input S12 SAS Secondary RS- Input
S6 SAS Primary RP+ Input S13 SAS Secondary RS+ Input
S7 Ground for SAS
Primary
Ground S14 Ground for SAS
Secondary
Ground
P1 +3.3V Power P8 +5.0V Power
P2 +3.3V Power P9 +5.0V Power
P3 +3.3V Pre-charge Power P10 Ground Ground
P4 Ground Ground P11 Ready LED, O.C.
Output, LOL = 15 mA
Output
P5 Ground Ground P12 Ground Power
P6 Ground Ground P13 +12.0V Pre-charge Power
P7 +5.0V Pre-charge Power P14 +12.0V Power
P15 +12V Power
Table 156 SSE Card Slot Data
Type of Card and Card Description Physical Slots
(1)
SmartEdge Storage Engine 2 HDD slots
(2)
(1) The SmartEdge OS does not support these ports directly.
(2) Supported by the CLI commands received from the Network Processor (NP) through the SAS controller.
The SSE card provides equipment LEDs at the top of each card to indicate the
current status of the card, and facility LEDs to indicate the status of the HDDs.
164
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
