ESAB Cutmaster 80 - Section 2 System: Introduction; How to Use this Manual; Equipment Identification; Receipt of Equipment

ESAB CUTMASTER 80
Manual0-5396 INTRODUCTION
2-1
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
ThisOwner’sManualappliestojustspecicationorpart
numbers listed on page i.
To ensuresafe operation,readthe entiremanual,in-
cluding the chapter on safety instructions and warnings.
Throughoutthismanual,thewordsDANGER,WARN-
ING,CAUTION,andNOTEmayappear. Paypar-
ticularattentiontotheinformationprovidedunderthese
headings. These special annotations are easily recog-
nizedasfollows:
NOTE!
Anoperation,procedure,orback-
ground information which requires
additional emphasis or is helpful in
efcientoperationofthesystem.
!
CAUTION
Aprocedurewhich,ifnotproperly
followed,maycausedamagetothe
equipment.
!
WARNING
Aprocedurewhich,ifnotproperly
followed,maycauseinjurytothe
operator or others in the operating
area.
WARNING
Givesinformationregardingpossible
electricalshockinjury.Warningswill
be enclosed in a box such as this.
DANGER
Meansimmediatehazardswhich,if
notavoided,willresultinimmediate,
seriouspersonalinjuryorlossoflife.
Additional copies of this manual may be purchased by
contacting ESAB at the address and phone number in
yourarealistedonbackcoverofthismanual.Include
theOwner’sManualnumberandequipmentidentica-
tion numbers.
Electronic copies of this manual can also be downloaded
at no charge in Acrobat PDF format by going to the ESAB
web site listed below
http://www.esab.eu
2.02 EquipmentIdentication
Theunit’sidentication number (specicationorpart
number),model,andserialnumberusuallyappearon
a data tag attached to the rear panel. Equipment which
doesnothaveadatatagsuchastorchandcableas-
sembliesareidentiedonlybythespecicationorpart
number printed on loosely attached card or the shipping
container. Record these numbers on the bottom of page
i for future reference.
2.03 Receipt Of Equipment
Whenyoureceivetheequipment,checkitagainstthe
invoicetomakesureitiscompleteand inspect the
equipment for possible damage due to shipping. If there
isanydamage,notifythecarrierimmediatelytolea
claim. Furnish complete information concerning damage
claims or shipping errors to the location in your area listed
intheinsidebackcoverofthismanual.
Includeallequipmentidenticationnumbersasdescribed
abovealongwithafulldescriptionofthepartsinerror.
Movetheequipmenttotheinstallationsitebefore
un-cratingtheunit.Usecaretoavoiddamaging the
equipmentwhenusingbars,hammers,etc.,toun-crate
the unit.