− 25 −
bi24d1ea
6.21 Dynamic regulation
The dynamic regulation function is developed for multiple electrode welding and
alters the characteristics of the power source. The characteristics of the power
source are calculated from the set wire data.
− Dynamic regulation is selected in the weld data setting menu under stop data.
6.22 Setting limits
For information about setting limits see chapter 9.4 ”Setting limit editor”
6.23 Measure limits
For information about measurement parameters see chapter 9.5 ”Measure limits
editor”
7 MEMORY MANAGEMENT
7.1 Control panel working method
The control panel can be said to comprise two units: working memory and weld data
memory.
Store
Working memory Weld data memory
Recall
In the working memory, a complete set of weld data settings is created that can be
stored in the weld data memory.
During welding, it is always the content of the working memory that controls the
process. It is therefore also possible to recall a weld data set from the weld data
memory to the working memory.
Note that the working memory always contains the most recently set weld data
settings. They can be recalled from the weld data memory or individually altered
settings. In other words, the working memory is never empty or “zeroed”.
Main menu MEMORY Weld data memory
WELD DATA MEMORY
1 −
2 −
3 −
4 −
5 −
6 −
7 −
STORE
2ND
FUNCT QUIT
GB
To Next Page
Loading...
