− 40 −
bi24d1ea
Specify the values to weld with two welding heads as follows:
Position the cursor on
the WELDING HEAD
row.
Select whether the set-
ting is to apply to
”master” control unit
HEAD or ”slave” control
unit TAIL.
MACHINE CONFIGURATION
PRODUCT CODE A2TFX
WIRE FEED AXIS"
TRAVEL AXIS"
TANDEM ON
b WELDING HEAD HEAD
b WELD HEAD OFFSET 20 mm
QUIT
S Position the cursor on the WELD HEAD OFFSET row and specify the distance
between the two welding heads.
Example
Welding head2, (slave) Welding head1, (master)
TAIL HEAD
WELD HEAD OFFSET
S Press Start, for welding head1 and welding head2 at the same time.
S Welding head1 starts to weld.
S Welding head2 starts to weld first when the start position for welding head1 has
been reached (the distance given WELD HEAD OFFSET).
S Press stop, for welding head1 and welding head2 at the same time.
S Welding head1 stops welding but travel motion continues.
S Welding head2 stops welding when it has reached the point where equipment1
stopped welding (the distance that is given in WELD HEAD OFFSET).
S Welding is complete.
GB
To Next Page
Loading...
