Selection of curve and check-points
6. Display mode
To display or mask XY markers.
To display or mask the markings of progressive lenses.
To display or mask the rough lens.
To display or mask the posiblock (after edging simulation).
(nonfunctional)
To display the initial form (before shape modification).
7. Display on the right side
Display on the left side
Display on both sides (in this view, you cannot modify the form).
8. Symmetrical mode
Modification of both sides simultaneously
Modification of each side separately
>The symmetrical mode is activated by default
9. To add a reference point
10. To remove a reference point
11. Tools for modifying “reference points”
Angle tool
Curved tool
12. Tools for modifying “segments”
◦ D-segment
◦ Curve segment
13. Reference point
14. Shape to be worked on
15. Information on the shape
To Next Page
Loading...