This chapter describes the maintenance procedures you can carry out on the edger without the aid of a
technician.
• Carrying out edger autotests (F p.153)
• Calibrating the touch screen (F p.154)
• (F p.174)Consulting the preventive maintenance screen of the “small tools” module (F p.155)
• Maintenance & servicing (F p.158)
• Viewing the statistics and technical log (jobs and actions carried out) (F p.174)
• Maintaining and cleaning the edger (F p.176)
1. CARRYING OUT THE AUTOTESTS
You can use this menu to carry out a self-diagnosis of the job functions of the edger.
To test the proper performance of the edger, select > > from your work screen.
1. Edger autotests
2. Initialisation and rotation of lens shafts
3. Reproducer: lens shaft raising and lowering
4. Right feeler movement
5. Left feeler movement
6. Closing of lens shafts
7. Wheel rotation
8. Rotation of Grooving/Milling/Drilling (GMD) module
To Next Page
Loading...
Need help?
General