Essilor Pro-E 700 edger - 1. EDGER WORKING ENVIRONMENT

To Next Page

To Previous Page

This chapter describes the work environment of the edger and the procedures for edging any type of lens:

• Edger working environment (F p.19)

• Perform a Beveling (F p.24)

• Beveling for a high-base frame (F p.32)

• Perform a Step bevel, (F p.40)

• Grooving (F p.49)

• Produce a Flat-edge finish (F p.57)

• Do a mixed job (F p.57)

• Perform a Drilled job (F p.62)

• Perform a Polishing (F p.67)

• Perform a Chamfering (F p.67)

• Perform a Retouching (F p.68)

• Perform a “Super Chamfer” (F p.70) (Pro-E 700)

• Perform a Chemistrie job (F p.72)

(Pro-E 700)

• Perform a Half-Jacket job (F p.81) (Pro-E 700)

• Create an engraving or a creative shape (F p.100) (Pro-E 700)

1. EDGER WORKING ENVIRONMENT

This section describes the edger working environment and the initial stages of the edging of a lens.

• Description of the edging screen (F p.20)

• Shape call-up procedure (F p.22)

• Putting the lens in place (F p.22)

USER MANUAL> II. EDGING A LENS

Pro-E 600_Pro-E 700 > v1 -10.18