◦ Milling
◦ Bevel
◦ Flat-edge finish
◦ Groove
◦ Drill-holes/oblong hole
◦ Notch
◦ Polishing
◦ Chamfer
◦ High-base bevel
◦ Step bevel
4. Drilling
Number of drilling operations performed for each lens material, according to the drill bit used.
5. Calibration of the touch screen
6. Number of lenses cut
7. Dressing cycle
Finishing wheel/Polishing wheel
8. Next page/Previous page
b. Technical log and errors
From the work screen, select > > to access the list of error messages.
The following screen is displayed:
1. Partial counter
Number of error messages displayed since the last reset to zero.
You can sort the error codes generated by the machine by frequency of appearance.
To Next Page
Loading...
Need help?
General