c. Screensaver
This menu enables you to configure a screensaver.
To access this menu from your work screen, select > > .
The following screen is displayed:
1. Screensaver display
Enable or disable the screensaver.
2. Triggering
Set the waiting time before the display of the screensaver (in seconds).
3. Transition
Set the transition time between each image (in seconds).
Once the modification has been made, press to go back to the work screen.
2. ADJUSTING THE PRECISION OF THE EDGER
This menu enables you to adjust the precision of the edger. You can adjust:
• the diameter of the finished lenses (F p.141)
• the position of the bevel and groove (F p.142)
• the diameter of drill holes (F p.143)
• the chamfer (F p.144)
• the depth and width of the groove (F p.142)
• engraving: number of strokes of the engraving tip. (F p.146)
• the position of high-base bevel (F p.149)
• the position of the step bevel (F p.149)
a. Adjusting the diameter of the finished lenses
If lenses of a particular material always seem too small or too big after edging, you can adjust their diameter
according to the type of frame.
To Next Page
Loading...
Need help?
General