Essilor Pro-E 700 edger User Manual

To use the creative shape modification tool
Press to start “Job Management”.
Select the job you wish to modify.
Press to access “the creative shape modification” menu.
The following screen will appear:
Press to select the point from which you wish to modify the shape
Press to select the “angle” tool
: Reference point: point from which the shape modification will be started.
: Check-points: points allowing you to modify the curve.
Press to add a reference point
To erase a point, select it with your mouse then press .
>
>
1
2
3
4
5
6
USER MANUAL> II. EDGING A LENS
121
Pro-E 600_Pro-E 700 > v1 -10.18

Essilor Pro-E 700 edger Specifications

General

Brand	Essilor
Model	Pro-E 700 edger
Category	Laboratory Equipment
Language	English