Essilor Pro-E 700 edger User Manual

• an engraving tip
• an Allen key
• an adjustable wrench
The engraving tip should only be in the edger when engraving cycles are being performed.
The chuck must always contain a tool to avoid any risk of oxidation.
You must replace the engraving tip with the drill bit as soon as you go back to the edging menu.
A warning message indicates that:
Block the axle with the blocking key.
Put the adjustable wrench on the chuck
The adjustable wrench must never touch the engraving tip or with the drill bit.
1
2
Pro-E 600_Pro-E 700 > v1 -10.18
172
USER MANUAL> V. MAINTENANCE & SERVICING

Essilor Pro-E 700 edger Specifications

General

Brand	Essilor
Model	Pro-E 700 edger
Category	Laboratory Equipment
Language	English