Essilor Pro-E 700 edger User Manual

12. Perform a “Super Chamfer” (Pro-E 700) 70
13. Perform a Chemistrie TM job (Pro-E 700) 72
a. Prerequisites 72
b. Preparing a Chemistrie TM job 73
c. Prepare the Chemistrie TM lenses 77
d. Cut a Chemistrie lens 78
14. Carry out a Half Jacket job (Pro-E 700) 81
a. Outline the step bevel trajectory on a Half Jacket shape 81
b. Finalize the step bevel settings in “front surface follow-up” mode 94
c. Modify the shape on Essibox 96
15. M’EYE Sign feature (Pro-E 700) 100
a. To prepare the engraving 100
b. Performing engraving 112
c. Setting up the favorites 116
16. M’EYE Touch feature (Pro-E 700) 117
a. On Essibox 118
b. On the edger 125
III. PREPARING A DRILLED JOB 127
1. Menu screen 129
2. Configuring a drilling point 130
a. Creating a drilling point 131
b. Dimensioning a drilling point 131
c. Adjusting the position of a drilling point 132
IV. CONFIGURING THE EDGER 137
1. Configure the edger 139
a. Time, date and language 139
b. Connections 140
c. Screensaver 141
2. Adjusting the precision of the edger 141
a. Adjusting the diameter of the finished lenses 141
b. Adjusting the position of the bevel and groove 142
c. Adjusting the diameter of drill-holes 143
d. Adjusting the chamfer 144
e. Adjusting the groove 145
f. To adjust the engraving 146
g. Adjust the position of high-base bevel 147
h. Adjust the position of the step bevel 149
3. Restore the factory settings 150
V. MAINTENANCE & SERVICING 151
1. Carrying out the autotests 153
2. Calibrating the touch screen 154
3. Consulting the preventive maintenance screen of the “small tools” module 155
4. Changing or cleaning the edger tools 158
a. Changing or cleaning the drill bit 159
b. Changing or cleaning the mill bit 162
c. Changing the chamfering wheel 165
d. Install and change the step bevel ++ tool 168
e. Installing and changing the engraving tip 171
USER MANUAL> CONTENTS

Essilor Pro-E 700 edger Specifications

General

Brand	Essilor
Model	Pro-E 700 edger
Category	Laboratory Equipment
Language	English