GROOVE FRAME LENS ADVANTAGES
Standard
groove
Lens for which the rear surface
base is not as high as the front
surface base.
Minimises the risks of the nylon thread coming out.
Standard
groove
Thin lens Makes it possible to balance out the groove when thin
lenses are used.
Flat base
High base
Thin lens for which the front
surface base is approximately
equal to the frame base.
In the event of pattern tracing (base = 0), makes it
possible to retrieve the frame base.
Call up the desired shape located on the tracer or on the job management program.
The shape is displayed on the edger work screen.
After tracing a pattern, demo lens or re-cut lens, without any drilling settings:
• the groove finish is selected by default.
• the automatic mode is selected by default.
Select lens material.
Change the edging mode. Press to select customized mode .
Select the type of cycle.
Choose whether or not to polish and/or chamfer your lens.
For more information, consult the section Edging a lens > Perform a polishing (F p.67) and Edging a
lens > Perform a chamfering (F p.67).
Press the “cycle start” button (front face) or .
The door closes, the lens is clamped and then felt.
The customized groove finish screen is displayed.
Select the type of customized groove you want to do.
Select the values you want to modify and press and to adjust them if necessary
To Next Page
Loading...