The result can be viewed in the zoom window and the display window of the bevel trajectory on the
lens section.
Press systematically to tilt of the bevel (mounting aid).
The bevel tilt is selected .
The result can be viewed in the zoom window.
Press the “cycle start” button (front face) or .
The edging cycle starts.
When the edging cycle is finished, the retouch screen is displayed.
Press to release the lens.
If necessary, retouch the lens.
Otherwise, start edging the second lens. Select the lens directly on the screen, on the left or right of the
work area.
To Next Page
Loading...
Need help?
General