EQT Router User Manual
Page 32 Revision 1.9.1
4.2.5. Configuring Network Settings
The Network Configuration menus are used to configure parameters associated with the Ethernet
communications of the device. The following chart provides a brief description of the items available in
the Network Configuration menu.
Set IP Address Sets the IP Address for the device.
Set Netmask Sets the subnet mask for the device.
Set Gateway Sets the Gateway for the device.
Set Broadcast Address Sets the Broadcast Address for the device.
Use DHCP Sets the Dynamic Host Configuration Protocol mode for the device.
View Live Network Settings Displays the current network settings of the device.
Note: The router must be rebooted in order for network changes to take effect.
Note: Menu settings for Q-Link and Video Reference are not applicable for the
–F fiber version of the EQT.
4.2.6. Setting the SNMP Setup
The SNMP Setup menus are used to configure parameters associated with the SNMP communications
of the device. The following chart provides a brief description of the items available in the SNMP Setup
menu.
Set Trap IP Address Sets the IP addresses that will receive traps from the device.
Remove Trap IP Address Removes IP addresses of devices receiving traps.
Set Read Only Community
String
Sets the Read Only community string for message authentication.
Set Read Write
Community String
Sets the Read Write community string for message authentication.
4.2.7. Setting the Status Monitoring
The Status Monitoring menus are used to view parameters associated with the crosspoint and
reclocker of the device. The following chart provides a brief description of the items available in the
Status Monitoring menu.
To Next Page
Loading...
Need help?
General
